A pack of drivers / dependency files has surfaced to install the Omnikey
to a Mipsel Dreambox. If you don't know a Mipsel dreambox is basically
the Enigma2 boxes, DM7025, 800 & 8000. This method is not applicable
for the older E1 boxes.
Basically the pack consists of 4 *.ipk installer files which will add the
required components to the Dreambox to run the Omnikey USB reader.
Your image will most likely have the ability to install these via your manual
install option in the addon panel, however to make sure everything is
correct I recommend you install via Telnet and follow this guide below.

FTP the 4 IPK files to your /tmp folder on the dreambox. Then start a
telnet session.

1. ipkg install /tmp/libusb_0.1.12-r0_mipsel.ipk


Code:

Installing libusb (0.1.12-r0) to root...
Configuring libusb

2. ipkg install /tmp/pcsc-lite_1.5.5-r0_mipsel.ipk

Installing pcsc-lite (1.5.5-r0) to root...
Configuring pcsc-lite
Adding system startup for /etc/init.d/pcscd ...
/etc/rc2.d/S20pcscd -> ../init.d/pcscd
/etc/rc3.d/S20pcscd -> ../init.d/pcscd
Starting PCSC Daemon: pcscd.
/etc/rc4.d/S20pcscd -> ../init.d/pcscd
/etc/rc5.d/S20pcscd -> ../init.d/pcscd
/etc/rc0.d/K20pcscd -> ../init.d/pcscd
/etc/rc1.d/K20pcscd -> ../init.d/pcscd
/etc/rc6.d/K20pcscd -> ../init.d/pcscd

3. ipkg install /tmp/libpcsclite1_1.5.5-r0_mipsel.ipk



Installing libpcsclite1 (1.5.5-r0) to root...
Configuring libpcsclite1

4. ipkg install /tmp/ccid_1.3.11-r0_mipsel.ipk

Installing ccid (1.3.11-r0) to root...
Configuring ccid

So, once all this is in place, connect the USB reader and set it
up in NewCS as normal. The reader type is
<type>pcsc</type>

The node address will be simply
<node>0</node>

If you add a second reader it will be
<node>1</node>